Canon Wireless Transmitter WFT-E5A Instruction Manual page 113

71: Cannot connect to slave cameras
Are you following the correct procedure to establish the connection with slave
cameras?
Operate slave cameras by following the correct instructions (p.70, 71).
Are the slave cameras too far from the master camera?
Bring the slave cameras closer to the master camera.
72: Cannot connect to the master camera
Are you following the correct procedure to establish the connection with master
camera?
Operate the master camera by following the correct instructions (p.70, 71).
Is the master camera too far from the slave cameras?
Bring the master camera closer to the slave cameras.
81: Wired LAN connection lost
Is the LAN cable securely connected?
Reconnect the LAN cable between the transmitter and server. Because the cable may be
severed, try using another cable to connect the devices.
Is the hub or router on?
Turn on the hub or router.
Is the server on?
Turn the server on. The server may have been turned off because of an energy-saving
mode.
99: Other error
Another problem has occurred, identified with an error number other than 11 to 81.
Turn the camera's power switch off and on.
Responding to Error Messages
113