Canon Wireless File Transmitter WFT-E4 II A Instruction Manual page 92

Connecting GPS Devices via Bluetooth
92
Select [OK].
5
After the Bluetooth unit is attached to the
transmitter, the transmitter's <USB> lamp blinks in
green and a message is displayed indicating that a
connection has been established.
When the confirmation message is displayed, select [OK].
At this point, the menu option [Disconnect]
becomes available. Select this option before
detaching the GPS device.
Establish a wireless connection between
6
the GPS device and Bluetooth unit.
Turn on the GPS device and activate Bluetooth® on it.
Select [Bluetooth device connection].
Nearby Bluetooth® devices in use are listed. (Only
GPS devices can be connected.)
Select the GPS device.
7
Press <0> to display the connection status of
Bluetooth® devices.
Pressing <0> when the status is [Not conn.] will
list nearby Bluetooth® devices in use.
Turn the <5> dial to select [GPS] , and then
press <0>.
Select [OK] and press <0>.
If a Bluetooth® password has been set on the
GPS device, a password input screen is displayed.
Enter the password.
The transmitter now starts to establish a
connection with the GPS device.
It may take a few minutes to establish a
connection with the GPS device.
Camera operations such as shooting, menu
display, or image playback are not possible
until the connection is established.