Advertisement
Available languages
Available languages
•
Never stand on tool. Serious injury could occur if tool
is tipped or if belt or disc are unintentionally contacted.
•
Know your tool. Learn the tool's operation, applica-
tion and specific limitations,
•
Use recommended accessories (refer to page 13).
Use of improper accessories may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Belt jams when it digs too
deeply into workpiece. (Motor force keeps it stuck in
the work.)
•
Support workpiece with miter gauge, belt platen,
work stop or work table.
• Maintain '/_6"maximum clearance between table and
sanding belt or disc.
CAUTION;
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING;
Do not attempt to operate tool until it is
completely assembled according to the instructions.
ATTACH ABRASIVE
DISC TO ALUMINUM
I
DISC
Refer to Figure 2.
•
Remove dust chute by looseningscrews and bolts,
• Remove the adhesive cover from the back of the
abrasive disc,
• Center abrasive on aluminumdisc and press to paste.
•
Make sure abrasive is pasted evenly on the aluminum
disc.
•
Replace dust chute
i
ATTACH DISC TABLE
Refer to Figure 2,
•
Set the disc table at right angle to the aluminum disc
and secure the table position using two knobs and
flat washers. Be sure that the gap between abrasive
disc and disc table is _/_6" or less.
• Attach pointer to side of dust chute using 4-0,7 x
8mm socket head bolt from hardware bag. Adjust
pointer to zero mark on trunnion and tighten bolt.
Aluminum Disc
withAbrasive
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a
claim must be filed with the carrier for fastest action.
Parts which need to be fastened to the unit should be
located and accounted for:
A Disc Table
B Abrasive Disc
C Miter Gauge Assembly
D 1" Belt
E Belt Table
Parts bag (Part No. 21489.00) includes: horizontal stop
bar, pointer, work stop, two knobs, one 10-1.50 x 25mm
socket head bolt, one 4-0.7 x 8mm socket head bolt,
one 10mm flat washer, two 6mm flat washers, one 8-
1.25mm hex nut, one each 3, 5, 6, and 8ram hex
wrenches and one extra long 3mm hex wrench.
A
--
.dc.--B
C
Figure 1 - Unpacking
Knob
FlatWasher
.-"
_'X
: Chute
Disc'_able T_Jion
"_8_ "Screw
Pointer
Figure 2 - Secure Disc Table and Aluminum Disc
ATTACH
BELT TABLE
Refer to Figure 3,
• Attach belt table to left side of belt housing using the
socket head bolt and flat washer from the hardware
bag.
• Set the belt table at right angle to the belt.
• Be sure that gap between belt table and belt is '/16"
or less.
• Tighten socket head bolt to secure belt table position.
Stop Bar
Belt Table
Refer to Figures 2 and 3.
CAUTION:
Do not attempt assembly if parts are miss-
ing. Use operator's manual to order replacement parts.
Figure 3 - Attach Belt Table
Head Bolt
3
Advertisement
