Chapter 2: Installation; Connecting Vhf And Uhf Antennas To The Tv/Vcr; Antennas With 300-Ohm Flat Twin Leads - Samsung CXD1332 Owner's Instructions Manual

I
NSTALLATION
In this chapter, you will learn to connect your TV/VCR. Choose which of the
following situations applies to your system, and follow the step-by-step instructions to
set up your new TV/VCR.
Connecting VHF and UHF Antennas
to the TV/VCR
If you do not have cable TV, you will connect the TV/VCR to one or more antennas.
Before connecting, however, you must determine what type of lead your antenna has
(The "lead" is the end of the antenna cable ).
If your lead looks like this,
you have a 300-ohm flat twin lead.
(This is the type of lead on the rod
antenna included with the unit ).
If your lead looks like this.
you have a 75-ohm round lead.
(This is the type of lead on a
coaxial cable ).

Antennas with 300-ohm Flat Twin Leads

The rod antenna included with your TV/VCR (except models CXD2512, CXD2514)
uses 300-ohm twin flat leads. If you are using a different antenna (like a roof antenna)
that also has 300-ohm twin flat leads, follow the directions below, but skip the first step
1
you want to use the
If
included rod antenna,
push the stem of the
antenna into the
antenna mount at the
top of the back panel.
2
Place the wires from the
antenna under the
screws on the 300-75
ohm adaptor (included).
Use a screwdriver to
tighten the screws.
3
Plug the adaptor into the
terminal on the bottom
of the back panel.
continued...
2 . 1
C T : I
H A P T E R W O N S T A L L A T I O N