Chevrolet VENTURE 1998 Manual page 373

4. Remove the bulb holder by pressing the four
retaining tabs and pulling the holder away from
the assembly.
5. Replace the bulb(s) by pulling the old one(s) out
and gently pushing the new one(s) into the bulb
holder socket.
A.
Tail Bulb
B. Back-up Bulb
C. Turn Signal Bulb
D. StoplI'ail Bulb
6. Snap the bulb holder back into place making sure all
retaining tabs are properly over the bulb holder tabs.
7.
Reinstall the taillamp assembly by inserting
the
outboard locatinghetaining pins until
the
lamp is
seated. Secure with the inboard screws.
For any bulb changing procedure not listed in this
section, contact your dealer service department.
6-38