Chevrolet TRACKER 2003 Manual page 121

Setting Cruise Control
1. Press the CRUISE
ON/OFF button on the
instrument panel to
turn the system on. The
indicator light in the
button will come on. Wait
at least one second
after turning the system
on before setting a
speed.
Once the CRUISE ON/OFF switch is turned on, it
will come on each time you start your vehicle
until you manually turn if off.
2.
Accelerate to the speed you want, rotate the switch
to COAST SET and release it; the CRUISE light will
come on. Cruise will not set below 25 mph (40 km/h).
3. Take your foot off the accelerator pedal.
Resuming a Set Speed
If you set your cruise control at a desired speed then
suspend cruise by applying the brake, pressing the
clutch pedal if you have a manual transmission
or pressing CANCEL, you don't need to reset it.
You may resume your previously set speed by briefly
turning the switch to RESUME, provided your speed has
not dropped below 25 mph (40 km/h). If your speed
has dropped below 25 mph (40 km/h), accelerate
to 25 mph (40 km/h) or greater then turn the switch to
resume. There is a short time delay after your speed is
suspended until you can reset the cruise control to
your desired speed.
Increasing Speed While Using Cruise
Control
There are two ways to go to a higher speed.
e
e
Use the accelerator pedal to go to a higher speed.
Turn the switch on the lever down to COAST SET
and release it. Take your foot off the accelerator
pedal. You'll now cruise at the higher speed.
Turn the switch on the lever up to RESUME
ACCEL. Hold the switch at RESUME ACCEL until
you get up to the speed you want, then release
the switch.
3-1 0