Step 2. Installing The Software - Plustek OPTICARD 611 (BUSINESS CARD) Manual

Step 2 . Installing the Software
Step 2 . Installing the Software
1. If the USB components on your computer are functioning correctly, they will
automatically detect the scanner causing the "Add New Hardware Wizard" or
"Found New Hardware Wizard" to be launched. Note: If your computer was off
when you connected the scanner, the "Add New Hardware Wizard" message will
be displayed when you turn the computer on and when Windows starts.
2. For Windows 2000
a. Click on the [Next] button when the "Add New Hardware Wizard" window is
displayed.
b. Select "Search For The Best Driver For Your Device [Recommended]" and
click on the [Next] button.
c. The next window will ask you where to search to find the drive. Select [CD-
ROM drive], and deselect [Floppy disk drives] if it is checked.
d. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive and then click on the [Next] button.
e. Click on the [Next] button in the window that appears.
f. During the process of the installation, a message "Digital Signature required"
might be prompted.
installation without any misgiving at your scanner functioning. Afterwards,
please skip to Step 5.
3. For Windows XP
a. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive.
b. Select "Install The Software Automatically [Recommended]" and click on the
[Next] button.
c. Click on the [Next] button in the window that appears. Afterwards, please skip
to Step 5.
Please ignore it, and click on [Yes] to continue the
8