Placing A Call; Chapter 3 Placing A Call And Other Basic Phone Task; Making Telephone Calls - Cisco 7960G - IP Phone VoIP User Manual

Making Telephone Calls

Placing a Call

Table 3-1 Placing calls on your Cisco IP Phone
If you want to...
use the receiver
dial from one of your multiple
lines
make a new call on the current
line
dial with the phone on hook
use a headset
use the speakerphone
Cisco IP Phone 7960 and 7940 Series User Guide
3-2
Ending a Call, page 3-4
•
• Muting a Call, page 3-5
• Putting a Call on Hold, page 3-6
Transferring a Call to Another Extension, page 3-7
•
• Redialing the Last Number Dialed, page 3-8
• How to Get Notified When a Busy Line is Available Using Cisco Call Back,
page 3-8
• Storing and Retrieving a Call Using Call Park, page 3-9
Answering Calls on Another Extension Using Call Pickup, page 3-10
•
Table 3-1 lists the different ways you can place a call with your Cisco IP Phone.
Then...
Lift the handset and dial the number.
Press the line button that corresponds with your extension and dial
the number that you want to reach.
Press the NewCall softkey and dial the number.
From the main screen, dial the number and press the Dial softkey.
The phone will not produce a dial tone until after you press the Dial
softkey.
You can also press a line button, the Headset button, the Speaker
button, or lift the receiver to place the call.
If you are dialing with the phone on hook, you cannot use *
Note
or # as the leading digit. If you need to use these keys, dial
with the phone off hook.
Press the Headset button and dial the number.
Press the Speaker button and dial the number.
Chapter 3 Placing a Call and Other Basic Phone Tasks
78-10182-08