HP C5644A - SureStore Travan T4i Tape Drive User Manual page 23

4 If your computer requires special rails or other hardware to install the tape drive, mount
them on the tape drive in this step. Many computers require no special mounting
hardware, however. If other devices in your computer are not mounted with special
rails or tray, proceed with the next section, "Installing the Tape Drive in the Bay" on
page 2-8.


If you are installing the drive in an HP NetServer E-series or an HP Vectra, attach
the HP rails to tape drive with the screws provided, as shown in figure 2.5.


If your computer uses mounting hardware (either rails or a tray) and you have a
spare set, attach them to the tape drive as directed in your computer documentation.


If you do not have the appropriate mounting hardware for your computer, contact
your computer dealer or manufacturer to purchase it. Attach the mounting hardware
to the tape drive, then proceed with the next section, "Installing the Tape Drive in
the Bay" on page 2-8.
Figure 2.5 Attaching rails for an HP NetServer E-Series or Vectra computer
Installing an Internal Tape Drive
Preparing the Tape Drive
Screws go into
bottom set of holes
on both rails and
tape drive
2-7