HP C4405A - Colorado 14GB Tape Drive User Manual page 49

installing Windows, re-installing your backup software, then selectively
restoring the rest of the files you need.
To use Disaster Recovery:
1. Replace any lost hard drives with comparable drives.
Note: In order to recover all of your information, Disaster Recovery
must have at least as much hard disk space as existed before the
drive failure.
2. Insert the Windows Startup Disk (diskette #1 of the DR Set) into your
machine's 3.5" boot floppy drive and restart your computer.
A DOS screen appears.
3. If a Windows Startup Diskette #2 was created, (not all systems require the
creation of a second diskette) insert that diskette into your machine's 3.5"
boot floppy drive, then press any key.
The Disaster Recovery screen appears.
4. If necessary, you can prepare your hard disk at this time using the following
tools, by pressing Enter:
DDIFF—Displays any differences between your current and original
hard drive configurations
*FDISK—Re-partitions your hard disk
Note: After using the FDISK utility, repeat steps 2-4 before continuing
with the recovery.
*FORMAT—Formats one or more partitioned drives
*SYS—Installs the system boot files onto the hard disk
*For instructions on the use of these utilities, please refer to your operating
system user manual or contact your operating system's manufacturer.
When you are done preparing your hard disk, at the prompt, type (Your
boot floppy drive letter):\RECOVER, and press Enter.
5. To continue with Disaster Recovery, press F5.
6. Your system files will be copied from the diskette to your hard drive.
Disaster Recovery for Windows 9x 49