4. Replace the top (vertical lift) cover on the library using two 10-24 x
0.50 screws on one side of the library and the connecting tabs on the
other side (Figure 3-5). You can wait to install the back left screw
until you complete step 6.
5. Install the forehead included in the upgrade kit with four 10-24 x 0.50
screws.
Figure 3-5
Replacing the Cover and Forehead
6. Replace the stop latch bracket on top of the library by following these
steps (see Figure 2-5 on page 2-9):
a. Install the stop latch by inserting the tab into the latch stop.
b. Re-install the screw into the top cover. The library is now secured
Chapter 3
inside the rack.
Upgrading a 40-Slot Library to 60 Slots
Connecting the Library Modules
3-9