Cisco 521SG - Unified IP Phone VoIP Administration Manual page 28

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Some menus require entering of more information or numbers.
Press 9 on the IVR menu to be guided through a list of commonly used tasks or
enter the number of the desired menu to go directly to that feature.
Enter the number of the settings you want to change:
• 1—Network
- 1—Connection Type—Recites the connection type.
Press 1 to change the connection type, then press 0 for DHCP or press1
for static IP.
To save, press1.
To review, press 2.
To reenter, press 3.
To exit, press *.
- 2—IP Address—Recites the IP address
- 3—Netmask—Recites the network mask.
- 4—Gateway Address—Recites the gateway IP address.
- 5—MAC Address—Recites the MAC (hardware) address.
- 6—DNS—Recites the primary DNS server address.
• 2—Protocol
- 1—Call Control Protocol—Recites the current call control protocol.
Press 1 to change, or * to go back.
- 2—Multicast Address—Recites the multicast address.
Press 1 to change, or * to go back.
- 3—CDP—Tells you if CDP is enabled.
Press 1 to change, or * to go back.
- 4—SPCP Auto Detection—Indicates that SPCP auto detection is
enabled.
Press 1 to change, or * to go back.
• 3— Other Options
- 1—Software Version—Recites the software version.
- 2—Primary Extension—Recites the primary extension.
- 3—Reboot—Reboots the phone. Hang up to exit.
1
27