Table of Contents
Advertisement
Caution
Never run the fuel tank completely empty! An irregular fuel supply can result in
poor ignition or misfiring. Unburnt fuel may get into the exhaust system and
damage the catalytic converter.
Digital clock
You can set the time with the reset button at the bottom right next to the
rev counter.
Set hours
– Turn the reset button to the left.
Setting minutes
– Turn the reset button to the right.
WARNING
The clock should not be adjusted while driving for safety reasons but only
when the vehicle is stationary!
Using the system
Safety
Fig. 3 Instrument
cluster: Digital clock
Driving Tips
General Maintenance
Instruments and Indicator/Warning Lights
Speedometer with counter for distance driven
The distance which you have driven with your vehicle is shown in kilometres (km).
On certain model versions, the readout is shown in "miles".
Bottom counter (trip counter) for distance driven
The bottom counter indicates the distance which you have driven since this
counter was last reset - in steps of 100 metres or 1/10 of a mile. It can be reset to
zero by pressing the reset button next to the trip counter
Top counter for distance driven
The top counter for distance driven indicates the total distance in kilometres or
miles which the vehicle has been driven.
Fault display
dEF will appear as a constant text in the display field of the counter for distance
driven if there is a fault in the instrument cluster. Have the fault rectified as soon as
possible by a specialist workshop.
Warning against excessive speeds*
An acoustic warning signal will sound when the vehicle speed exceeds 120 kilome-
tres per hour. The acoustic warning signal will switch off again when the vehicle
speed goes below this speed limit.
This function is only valid for some countries.
Breakdown assistance
13
Fig. 4 Instrument
cluster: Counter for
distance driven
⇒ fig.
4.
Technical Data
Advertisement
Table of Contents
