Range Selector Key Setup; Tone Settings; System Settings; Radio Set-Ups - Skoda RADIO NAVIGATION SYSTEM AMUNDSEN - FOR OCTAVIA 05-2009 Manual

10

Range selector key SETUP

Range selector key SETUP

Tone settings

By pressing the button SETUP and pressing on the function key
mode, you can select the following parameters using the menu control button
•
Volume - Maximum switch on volume
Navigation volume and Speed dependent vol Adjustment
on, volume of incoming traffic announcements, volume of navigation announce-
ments and speed dependent volume adjustment;
•
- Treble setting;
Treble
•
Midtone - Midtone setting;
•
- Bass setting;
Bass
•
- Setting of the volume ratio between the left and right side;
Balance
•
- Setting of the volume ratio between the front and the rear;
Fader
•
EQ Settings * - Setting the equalizer (linear, language, rock, classical, dance);
•
* - setting of the surround tone.
Surround
GALA function
Your radio increases automatically its volume with the increasing vehicle speed. A
higher setting value results in a stronger volume increase.
Note
You can set the tone parameters using the menu control button
keys or .
+ -

System settings

Press the button and select the function key
SETUP
You can select between the following parameters:
•
- Menu language for the displays and the language messages;
Language
Tone in the RADIO
, Traffic announcements (TP) ,
- Volume when switching
A
or the function
10
.
System
•
- Keypad display for text entry;
Keypad display
•
* - if your vehicle is equipped with climatronic, the setting
A/C display time
change is displayed when it is activated;
•
A
:
- Setting the brightness of the screen;
10 Screen
•
- Factory settings;
Factory settings
•
- the information regarding the complete memory capacity of
SD card status
the SD card and the size of the memory assigned to the navigation data is displayed
on the screen;
•
- Removing the SD card.
Remove SD card

Radio set-ups

Press the button
SETUP
Switching the traffic announcements on or off
– If you wish to switch the reception of traffic reports on or off, press the
function key
Traffic information (TP)
Determining the station selection via the
– By pressing on
Station list
from which the stations are to be selected while in the RADIO mode
using the arrow keys. If the
stations from the memory list are called up. The symbol "
displayed on the screen.
Switching the RDS function on or off (RDS regional)
– Press on the function key
set-up in the opening pop-up window.
in the RADIO mode.
.
Arrow keys
or , you can select the source
Memory list
Memory list is selected, only stored
(regional station) and select a
RDS regional
" is