Table of Contents
Advertisement
78
Seats and Stowage
– Engage the reverse gear.
– Move the right exterior mirror into the desired position ⇒ page 73.
– Take the vehicle out of gear. The set position of the exterior mirror is
stored.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
A
⇒ page 77, fig.
memory buttons
B
A
corresponding memory button
cally moved into the positions which have been allocated to this button ⇒ page 78.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Note
When storing settings with the memory buttons, we recommend that you begin
with the front button and assign a memory button to each additional driver.
Each new setting stored with the same button erases the previous setting.
Each time you store the seat and exterior mirror settings for driving forward you
also have to re-store the individual setting of the exterior mirror on the passenger
side for reversing.
Assigning remote control to the memory buttons
After storing the settings of the seat and exterior mirrors, you have 10
seconds in order to assign the radio remote control to the appropriate
memory button.
– Withdraw the ignition key.
– Press the unlock button ⇒ page 50. The setting is stored with the
memory button which you have selected.
76, that is three in total. After pressing the
, the seat and the exterior mirror are automati-
B
If you wish to be able to retrieve the settings which are stored in the memory by also
using the radio remote control, you have to assign the radio remote control to a
memory button in each case.
If you wish, you can obtain an additional remote control key from an authorised
Škoda Service partner and then assign the remote control key to another memory
button.
Note
If the radio remote control had previously been assigned to another memory
button, this setting is then erased by the new assignment.
If you assign the radio remote control to a memory button which has already
been assigned to a radio remote control, the old assignment is also replaced by a
new assignment in this case.
The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory buttons
or with the remote control*.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibilities:
– One-touch automatic memory: Briefly press the desired memory
A
⇒ page 77, fig.
button
76. The seat and exterior mirror are moved
B
automatically into the stored positions (this applies only if the ignition
is switched on and the speed is less than 5 km/h).
– Memory keying: Press and hold the desired memory button
pressed long enough until the seat and the exterior mirror are moved
into the stored positions.
A
B
Advertisement
Table of Contents
