Table of Contents
Advertisement
210
Towing a trailer
of the engine speed. One should also not drop a gear for this reason when towing
a trailer as long as the engine can manage the slope without any drop in speed.
Detachable towing device*
The detachable ball head of the towing device is stowed in a box for the car tool kit
in the spare wheel well in the luggage compartment.
An instruction for correct installation and removal of the ball head of the towing
device is supplied with the ball head
Inspect the ball head to ensure that it is properly locked each time before setting off.
The inspection is performed by turning the closed locking lever downwards. If the
locking lever can only be turned around a small angle (approx. 5°), the locking
mechanism is O.K. After the inspection pull the locking lever back again to its stop.
The towing device must not be used, if it does not wish to close or the locking lever
turns slightly in the closed position.
WARNING
Do not use any aids or tools for installing or removing the ball head. This
might result in damage to the locking mechanism to the extent that the
safety of the towing device is no longer assured - risk of an accident.
components on the towing device.
whether the end cover properly seals off the mounting shaft.
steam jet. Ensure that the end cover properly seals the mounting shaft.
Fig. 203 Detachable ball
head
Note
Do not carry out any modifications or repairs to the ball head or to any other
Contact a specialist garage if you encounter any problems using the device.
Never unlock the ball head with a trailer coupled to it.
You should take off the ball head if you drive without towing a trailer. Inspect
Remove the ball head beforehand if you wish to clean your vehicle using a
It is recommended to wear gloves when installing and removing.
Advertisement
Table of Contents
