Connecting Antenna - Zenith ZLD20A1 Operating Manual & Warranty

Connecting antenna

* To get better picture quality, adjust the direction of antenna.
Connecting to wall antenna socket
Connecting to wall antenna socket
In case of wall antenna socket in apartment houses, connect the antenna cable as shown below.
(Use the correct type of antenna cable to the type of wall antenna socket.)
Apartments
* In case of 75Ω round cable, insert the bronze wire and then tighten the connecting nut.
And in case of 300Ω flat cable, connect the twisted wire to the antenna converter and
then connect the converter to the antenna input port.
* When using 75Ω round cable, do not bend bronze. It may cause poor picture quality.
Connecting to outdoor antenna
Connecting to outdoor antenna
This type of antenna is usually used at common private houses.
antenna
Private house
* In poor signal area, you can get better
picture quality if you install the anten-
na like the figure as shown right.
* If an antenna is divided to two TV
sets, use "signal divider" for connect-
ing.
206-3699
75Ω round cable
300Ω flat cable
wall connecting port
VHF antenna
75Ω round cable
UHF
300Ω flat cable
VHF
Turn clock arise to
tighten.
bronze wire L R R L
IDEO AUDIO
SPEAKER OUT
MONITOR OUT
4 /3W
antenna
converter
antenna input port
Turn clock arise to
tighten.
bronze wire
L
L AUDIO R R
SPEAKER OUT
OR OUT
4 /3W
antenna
converter
antenna input port
O R VIDEO L AUDIO R R
UHF
SPEAKER OUT
MONITOR OUT
4 /3W
signal
amplifier
DC OUT
ANT IN
LL
75 12V/0.2A
ANT IN DC OUT
LL 75 12V/0.2A
L ANT IN DC OUT
LL 75
12V/0.2A
15