Table of Contents
Advertisement
Turning on the set
* First, connect antenna cable and power cord with the adaptor.
* Press the power button and you will get stable picture and sound in a few seconds.
* See page 31 to memorize the channels available in your local broadcast area.
power
1
Press the
button to turn the set on.
If the set is in standby mode, press the power, ch
tv/video and number button on the remote control or
tv/video ch
( D,E )
Press the power button on the remote control. The set
reverts to standby mode.
Press the power button again to turn the set off.
displayed only in
stereo signal
channel number
2
Press the channel (
D,E
a channel you want after memorizing received broad-
casting signals in the local area.
Direct selecting channels
Press number of the program as one or two digits with
number buttons.
ex: channel 7
Refer to page 31 ~ 32 to memorize channels.
Adjust Volume level.
3
Volume (
) button increas-
G
es the level of sound.
Volume (
) button decreas-
F
es the level of sound.
* If you want to turn the set off, press the power button
on the front panel of the set or disconnect the power
plug to the wall outlet socket.
22
on the set to turn on it fully.
ST.
7
) or number buttons to select
7 or 07
Volume
3
( D,E ),
power
1
2
4
5
7
8
flashbk
0
menu
ch
vol
enter
ch
tv/video
3
6
9
cc
mute
vol
sleep
206-3699
Advertisement
Table of Contents
