ViewSonic PJL6243 User Manual page 55

Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the
back of the projector is switchable for computer input
or monitor output. (See page 9) Select Computer 2 or
Monitor Out with the Point ▲▼ buttons.
Computer 2 . . computer input
Monitor Out . . monitor out
Terminal function is not available when selecting
Computer 2 to the input source. Change the input
source to the others (Computer 1, and so on) so that
the Terminal function will be available. (pp.25, 36, 37)
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off
the projection lamp when the projector is not operated
for a certain period.
Select one of the following options:
Ready ...............
When the lamp has been fully
cooled down, the POWER
indicator changes to green
blinking. In this condition, the
projection lamp will be turned on
if the input signal is reconnected
or any button on the top control or
remote control is pressed.
Shut down .......
When the lamp has been fully
cooled down, the power will be
turned off.
Off .................... Power management function is
off.
Timer ................ If the input signal is interrupted
and no button is pressed for more
than 30 seconds, the timer display
with No signal appears. It starts
the countdown until the lamp is
turned off. Use the Point ▲▼
buttons to set the Timer (1~30
min).
Note:
Factory default is Ready: 5 min.
Direct on
When this function is set to On, the projector will be
automatically turned on just by connecting the AC
power cord to a wall outlet.
Note:
Be sure to turn off the projector properly (see
"Turning Off the Projector" on page 20). If
the projector is turned off in the incorrect
sequence, the Direct on function will not work
properly.
ViewSonic
Power management
Time left before Lamp is off.
49
49
Setting
PJL6243