Table of Contents
Advertisement
Current FSB Frequency
Detect Front Side Bus automatically.
Current DRAM Frequency
Detect DRAM fruquency automatically.
DRAM Clock
By SPD
200MHz
266MHz
DRAM Timing
Auto By SPD
Manual
When DRAM Timing set to Manual , user can select SDRAM CAS Latency DDR2 / Bank leterleve
/ Precharge to Active (Trp) / Active to CMD (Trcd) / REP to ACT/ REF(Trfc) /
ACT(0) to ACT(1) (TRRD) .Users can adjust these items based on their requirements.
SDRAM CAS Latency DDR2
Set SDRAM CAS Latency DDR2 is 4.
Bank Interleave
Set bank interleave to Disabled.
Precharge to Active (Trp)
Set precharge to active to 4T
Active to Precharge (Tras)
Set Active to precharge to 07T
Active to CMD (Trcd)
Set Active to CMD to 4T
REP to ACT / REF(Trfc)
Set REP to ACT / REF to 21T
ACT(0) to ACT(1) (TRRD)
Set ACT(0) to ACT(1) to 3T
Read to Precharge (Trtp)
2T
3T
Write to Read CMD (Twtr)
1T/2T
2T/3T
Write Recovery Time (Twr)
Set write recovery time to 2T/3T/4T/5T. (Default value:4T)
GA-7CN700ID Motherboard
Set DRAM Clock by SPD.(Default Value)
Set DRAM Clock to 200MHz.
Set DRAM Clock to 266MHz.
Set DRAM timing auto by SPD.(Default Value)
Set DRAM timing by manually.
Set Read to Precharge is 2T.(Default value)
Set Read to Precharge is 3T.
Set write to read CMD is 1T/2T.(Default value)
Set write to read CMD is 2T/3T.
- 28 -
Advertisement
Table of Contents
