Configuring Your Computer; Windows ® 000 - D-Link DSL-2320B - 24 Mbps DSL Modem User Manual

Section 4 - Configuring Your Computer
Prior to accessing the modem through the LAN or USB port, note the following necessary configurations:
• Your PC's TCP/IP address: 19.168.1.x (where "x" is any number between  and 54)
• The modem's default IP address: 19.168.1.1
• Subnet mask: 55.55.55.0
Below are the procedures for configuring your computer. Follow the instructions for the operating system that you are
using.
These are instructions for configuring your Windows
proceed to page 15.
1. In the Windows taskbar, click on the Start button and point to Settings > Control Panel > Network and
Dial-up Connections (in that order).
. Click on Local Area Connection. When you have the Local Area Connection Status window open, click
on Properties.
3. Listed in the window are the installed network components. If the list includes Internet Protocol (TCP/IP),
then the protocol has already been enabled, and you can skip to Step 10.
4. If Internet Protocol (TCP/IP) does not appear as an installed component, then click on Install.
5. In the Select Network Component Type window, click on protocol and then the Add button.
6. Select Internet Protocol (TCP/IP) from the list and then click on OK.
D-Link DSL-30B ADSL+ Ethernet/USB Modem User Manual

Configuring Your Computer

Windows 2000
®
®
000 operating system. If you are using Windows
®
XP please
14