Unpacking And Cleaning - Delta 11-990C Instruction Manual

Your drill press is shipped complete in one container. Carefully unpack the drill press and all loose items from the
container. Figure 2 illustrates the drill press and all loose items supplied with the machine. After assembly remove the
protective coating from the table surface. This coating may be removed with a soft cloth moistened with kerosene (do
not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, it is good practice to cover the table
surface with a good quality paste wax. Buff out the wax thoroughly to prevent it from rubbing into your workpiece.
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE
INSTRUCTION MANUAL.
11
13
8
10
1 - Drill Press Head and Motor
2 - Column, Base Flange and Table Raising
Mechanism
3 - Clamp Handle
4 - Table
5 - Base
6 - Pinon Shaft Handles (3)
7 - Chuck
8 - Chuck Key

UNPACKING AND CLEANING

4
7
3
6
9
12
1
Fig. 2
9 - Wrenches (2)
10 - Worm Gear for Table Raising and Lowering
Mechanism
11 - Table Raising and Lowering Handle
12 - 25mm (1") long Hex Head Cap Screws (4)
13 - 125mm (5") long Carriage Screws (2), Flat Washers
(2), Lock Washers (2), Hex Nuts (2)
4
2
5