Precautions; Connecting; Disconnecting - Toshiba Satellite P10-304 User Manual

Precautions

■
Make a back-up of your data before transferring it to the computer.
There is a possibility that the original data will be damaged. There is a
particular risk that some frames will be deleted in the case of digital
video transfer.
■
Do not transfer data in areas where static electricity is easily
generated or in areas subjected to electronic noise. Data can be
destroyed.
■
If you are transferring data through an IEEE1394 hub, do not connect
or disconnect other devices from the hub during data transfer. There
is a likelihood that data will be damaged. Connect all devices to the
hub before you turn on the computer's power.

Connecting

1. Make sure the connectors are properly aligned and plug the i.LINK
(IEEE1394) cable into the computer.
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
■
You may need to install drivers for your i.LINK devices.
■
Not all i.LINK devices have been tested. Therefore, compatibility with
all i.LINK devices cannot be guaranteed.
■
Use S100, S200 or S400 cables no longer than three meters.
■
Some devices might not support standby or automatic off functions.
■
Do not connect or disconnect an i.LINK device while it is using an
application or when the computer is automatically shutting it down to
save power. Data might be destroyed.

Disconnecting

1. Click the Eject or Remove Hardware icon on the Task Bar.
2. Point to i.LINK (IEEE1394) device and click.
3. Disconnect the cable from the computer then from the i.LINK device.
Refer also to the documentation that came with your i.LINK device.
Satellite P10 Series
Optional Devices
7-14