Table of Contents
Advertisement
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR. This function allows your
computer to receive and "wake-up" by
an incoming call to the modem when
in suspend state. See the table on the
right for pin defi nitions. You must have
a Wake-On-Ring card and cable to use
this feature.
Compact Flash Power
Headers
A Compact Flash Card Power Connec-
tor is located at JWF1. For the Com-
pact Flash Card to work properly, you
will fi rst need to connect the device's
power cable to JWF1 and correctly set
the Compact Flash Jumper (JP1).
SGPIO
SGPIO1 and SGPIO2 (Serial General
Purpose Input/Output) provide a bus
between the SATA controller and
the SATA drive backplane to provide
SATA enclosure management func-
tions. Connect the appropriate cables
from the backplane to the SGPIO1
and SGPIO2 header(s) to utilize
SATA management functions on your
system.
Chapter 5: Advanced Serverboard Setup
Wake-On-Ring
Pin Defi nitions
Pin#
1
2
Compact Flash
Power Header
Pin Defi nitions (JWF1)
Pin#
Defi nition
1
+5V
2
Ground
3
Signal
SGPIO Header
Pin Defi nitions (SGPIO1, SGPIO2)
Pin#
Defi nition
1
NC
3
Ground
5
Load
7
NC
Note: NC indicates no connection.
5-17
(JWOR)
Defi nition
Ground (Black)
Wake-up
Pin #
Defi nition
2
NC
4
Data
6
Ground
8
NC
Advertisement
Table of Contents
