Connecting Cables; Connecting Data Cables; Connecting Power Cables - Supero AS2041M-32R Plus User Manual

5-3

Connecting Cables

Now that the processors are installed, the next step is to connect the cables to
the serverboard. These include the data (ribbon) cables for the peripherals and
control panel and the power cables.

Connecting Data Cables

The ribbon cables used to transfer data from the peripheral devices have been
carefully routed in preconfi gured systems to prevent them from blocking the fl ow
of cooling air that moves through the system from front to back. If you need to
disconnect any of these cables, you should take care to reroute them as they
were originally after reconnecting them (make sure the red wires connect to the
pin 1 locations). If you are confi guring the system, keep the airfl ow in mind when
routing the cables. The following data cables (with their serverboard connector
locations noted) should be connected. See the serverboard layout diagram in this
chapter for connector locations.
Floppy Drive cable (JFDD1)
DVD-ROM Drive cable (IDE#1)
Control Panel cable (JF1, see next page)
SATA cables (SATA0 ~ SATA3)

Connecting Power Cables

The H8QM3-2/H8QMi-2 has a 24-pin primary power supply connector designated
"J1B1" for connection to the ATX power supply. Connect the appropriate connec-
tor from the power supply to JPW1 to supply power to the serverboard. See the
Connector Defi nitions section in this chapter for power connector pin defi nitions.
In addition, your power supply must be connected to both 8-pin Processor Power
connections at JPW1 and JPW2.
Chapter 5: Advanced Serverboard Setup
5-5