Table of Contents
Advertisement
Unpacking and Handling Procedures
Western Digital hard drives are precision instruments and should be handled with care during
unpacking and installation. Hard drives can be damaged by rough handling, shock and
vibration, or electrostatic discharge (ESD). Be aware of the following precautions when
unpacking and installing your Western Digital hard drive:
Do not unpack your hard drive until you are ready to install it. Your hard drive is
!
packaged in an anti-static bag.
Save the packaging materials and anti-static bag in case you need to return your hard
!
drive. Your warranty will be void if your returned hard drive is shipped in anything other
than the original packaging or Western Digital approved materials.
To avoid ESD problems, ground yourself by touching the metal chassis of the computer
!
before handling the hard drive. Articles of clothing generate static electricity. Do not
allow clothing to come in direct contact with the hard drive or circuit board components.
Handle the hard drive by its sides only. Avoid touching the circuit board components on
!
the bottom of the hard drive.
Do not drop, shake, or knock down the hard drive.
!
Do not stack hard drives or stand your Western Digital hard drive on its edge.
!
Record Your Hard Drive Information
In the table that follows, write down the serial number, model number, and date code listed
on your new Western Digital hard drive. The complete serial number, model number, and
date code are on the large label at the top of the drive. This information is required for
technical support purposes. See the illustrations below for reference.
IMPORTANT: Do not remove, tear, or damage the tape seal or any labels from the drive;
these actions will void the warranty.
Serial Number:
Model Number:
Model Number
Date Code
Date Code:
Serial Number
MDL: WD xxxxxx
Western Digital EIDE Hard Drive
WESTERN DIGITAL EIDE HARD DRIVE
S/N: WMxxx
000 xxxx
BEFORE GETTING STARTED - 2
INSTALLATION GUIDE
Hide quick links:
Advertisement
Table of Contents
