Preparation; How To Attach/Detach The Faceplate; How To Reset Your Unit; How To Prepare The Remote Controller - Kenwood KDC-X396 Instruction Manual

Preparation

How to attach/detach the faceplate

1
2
Do not expose the faceplate to direct
sunlight, excessive heat, or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
Keep the faceplate in its casing while
detached.
The faceplate is a precision piece of
equipment and can be damaged by shocks
or jolts.
To prevent deterioration, do not touch the
terminals of the unit and faceplate with
your fingers.

How to reset your unit

1
2
3
Reset button
How to prepare the remote
controller (RC-405)
(except for
When you use the remote controller for the
first time, pull out the insulation sheet.
4
2
If this unit fails to operate
properly, press the reset
button.
The unit returns to
factory settings when
the reset button is
pressed.
)
Insulation sheet
If the effectiveness of the remote
controller decreases, replace the battery.
1
1
CALIFORNIA, USA ONLY
This perchlorate WARNING applies only
to the product sold or distributed in
California USA "Perchlorate Material–special
handling may apply, See www.dtsc.ca.gov/
hazardouswaste/perchlorate. "
Caution:
Do not set the remote control in hot places
such as on the dashboard.
Lithium battery.
Danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
The battery pack or batteries shall not be
exposed to excessive heat such sunshine,
fire or the like.
Keep battery out of reach of children and in
original package until ready to use. Dispose
of used batteries promptly. If swallowed
contact physician immediately.
Remote controller (RC-405) is equipped
for
2
4
3
.