Memory Problems - Dell Vostro 400 Owner's Manual

F L E X B A Y D E V I C E I S
There is a FlexBay disable option in the BIOS setup that appears only when the
FlexBay device is installed. If the FlexBay device is physically installed, but it is not
running, check to see if it is enabled in the BIOS setup.

Memory Problems

CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
I F Y O U R E C E I V E A N I N S U F F I C I E N T M E M O R Y M E S S A G E
• Save and close any open files and exit any open programs you are not using to see if
that resolves the problem.
• See the software documentation for minimum memory requirements. If necessary,
install additional memory (see "Memory Installation Guidelines" on page 112).
• Reseat the memory modules (see "Installing Memory" on page 113) to ensure that
your computer is successfully communicating with the memory.
• Run the Dell Diagnostics (see "Dell Diagnostics" on page 86).
I F Y O U E X P E R I E N C E O T H E R M E M O R Y P R O B L E M S
• Reseat the memory modules (see "Memory Installation Guidelines" on page 112)
to ensure that your computer is successfully communicating with the memory.
• Ensure that you are following the memory installation guidelines (see "Installing
Memory" on page 113).
• Your computer supports DDR2 memory. For more information about the type of
memory supported by your computer, see "Memory" on page 169.
• Run the Dell Diagnostics (see "Dell Diagnostics" on page 86).
D I S A B L E D —
—
—
Solving Problems
71