HP dx2300 - Microtower PC Hardware Reference Manual page 25

5. Remove the computer access panel.
6. Locate the battery and battery holder on the system board.
7. Depending on the type of battery holder on the system board, complete the following instructions
to replace the battery.
Type 1
a. Lift the battery out of its holder.
Figure 3-1
b. Slide the replacement battery into position, positive side up. The battery holder automatically
secures the battery in the proper position.
Type 2
a. To release the battery from its holder, squeeze the metal clamp that extends above one edge
of the battery. When the battery pops up, lift it out (1).
ENWW
NOTE: On some computer models, it may be necessary to remove an internal component
to gain access to the battery.
Removing a Coin Cell Battery (Type 1)
19