HP dx2300 - Microtower PC Hardware Reference Manual page 17

6. Hold the expansion card just above the expansion socket on the system board then move the card
toward the rear of the chassis so that the bottom of the bracket on the card slides into the small
slot on the chassis. Press the card straight down into the expansion socket on the system board.
Figure 2-7
NOTE:
connector seats properly in the expansion card slot.
7. While holding the expansion card bracket against the chassis, slide the slot cover lock down toward
the expansion card brackets and slot covers to secure them in place then replace the screw that
secures the slot cover lock.
8. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
9. Replace the computer access panel and reconnect the power cord.
NOTE:
CAUTION:
slot cover for proper cooling of internal components during operation.
ENWW
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole
To remove an expansion card, reverse the installation procedure.
After removing an expansion card, you must replace it with a new card or expansion
Installing an Expansion Card 11