Pioneer DV320K - MULTISYSTEM REGION FREE DVD PLAYER.ALL REGIONS 0-6 Operating Instructions Manual page 36

Appendix
Additional information
06
Problem
Sound is not produced or is
distorted.
96 kHz/ 88.2 kHz digital audio
signals are not output from the
DIGITAL AUDIO OUT
(COAXIAL/ OPTICAL) termi-
nals.
Multichannel audio signals are
not output.
36
En
Check
Is the pause, frame-by-frame
forward or reverse, or slow play
mode set?
Are the connected devices (AV
receiver or amplifier, etc.) properly
set?
Is the disc scratched?
Is the disc dirty?
Are the audio cords properly con-
nected?
Are the audio cords damaged?
Is the player properly connected to
the other devices (AV receiver or
amplifier, etc.)?
Is the other device (AV receiver or
amplifier, etc.) connected to the
DIGITAL AUDIO OUT (COAXIAL/
OPTICAL) terminals?
Is Digital Out set to On?
Is the audio output properly set
on the connected AV receiver or
amplifier, etc.?
Is Digital Audio Out set to audio
signals the AV receiver or ampli-
fier, etc., supports?
Remedy
No sound is output during pause, frame-
by-frame forward/ reverse or slow motion
playback.
Refer to the TV's operating instructions and
check the settings (volume, input, speaker
settings, etc.).
Scratched discs may not play.
Wipe the dirt off the disc (page 44).
Connect the cord properly, inserting the
plug all the way in.
If the audio cord is damaged, replace it with
a new cord.
Check whether you are mistakenly con-
nected to the other device's audio output
terminals, etc.
Check whether you are mistakenly con-
nected to the AV receiver or amplifier's
PHONO input terminals, etc.
When connected to the DIGITAL AUDIO
OUT (COAXIAL/ OPTICAL) terminals, set
Digital Out to On (page 28).
Refer to the connected AV receiver or ampli-
fier's operating instructions and check the
audio signals it supports.
Set Digital Audio Out according to the
audio signals supported by the AV receiver
or amplifier, etc. (page 28).
When connected to the DIGITAL AUDIO
OUT (COAXIAL/ OPTICAL) terminals, set
Digital Out to On (page 28).
Refer to the connected AV receiver or ampli-
fier's operating instructions and check the
audio output settings.
Switch the disc's audio to multichannel
audio using the menu screen or AUDIO.
Refer to the connected AV receiver or ampli-
fier's operating instructions and check the
audio signals it supports.
Set Digital Audio Out according to the
audio signals supported by the AV receiver
or amplifier, etc. (page 28).