Internal Sd Module; Installing The Internal Sd Module; Internal Sd Module (Optional) - Dell PowerEdge T710 Hardware Owner's Manual

Internal SD Module

Installing the Internal SD Module

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Position the module so the tabs on the underside of the tray fit into the
hooks on the chassis, then lower the opposite edge of the card into place.
See Figure 3-18.
Only trained service technicians are authorized to remove the system
Installing System Components
119