Magnavox MRV700VR - Dvd Recorder / Vcr Owner's Manual page 13

E9490UD_EN.qx3 04.9.21
1
Connect your Antenna or Cable TV signal to the ANTENNA IN jack
on the rear of the Recorder.
2
Connect an S-Video cable (not supplied) to the Recorder's S-VIDEO
OUT jack and to the TV's S-VIDEO In jack.
3
Connect the supplied audio cable to the Recorder's white/red
AUDIO OUT L/R (left/right) jacks and to the left/right AUDIO IN
jacks on the TV.
4
Connect the supplied RF coaxial cable to the ANTENNA OUT jack
on the rear of the Recorder. Connect the other end of the same RF
coaxial cable to the Antenna In jack on your TV.
jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV's manual for
details.
5
Connect the power cords of the Recorder and the TV to a power
outlet.
6
Press STANDBY-ON
appears on the display panel, you need to turn on your TV and set it to the
S-Video In channel. (See next step.) You cannot see the Initial Setup screens
until you turn on the TV and have it on the correct S-Video In channel.
7
Turn on the TV power. Set the TV to the S-Video In channel.
not channel 3 or 4 when you are using S-Video. Your TV remote may have a
button or switch that selects the S-Video In channel. Or, go to your lowest TV
channel and change channels down until you see the DVD background picture
or Initial Setup screen on the TV. The Initial Setup screen will appear the first time
you turn on the Recorder. Go to page 18 to continue.
10:54 AM Page 13
Connecting to a TV Only
TV has an S-Video In Jack
Match the cable colors to the jack colors.
y y to turn on the Recorder. If "IS TV ON? C03"
Hookups (cont'd) 13
Your TV's Antenna In
This is
Helpful Hint
• On the TV, the S-Video In jack
may be labeled Y/C, S-Video, or
S-VHS (super video).