Motor Protection Filter; Exhaust Filter; Safety Cut-Out - Morphy Richards STORM LIGHT UPRIGHT VACUUM CLEANER - REV 3 Manual

73373 rev3 10/1/08
˘
˜
ˆ
˘
¯
‚
6
F F o o r r A A d d v v i i c c e e , , S S p p a a r r e e s s o o r r A A c c c c e e s s s s o o r r i i e e s s , , t t e e l l : :
14:51 Page 6
Cleaning the dust
J
canister filter
assembly
1 Operate the filter cleaning dial
fi several times and empty the
dust canister over a bin.
2 To access the filter assembly,
rotate the dust canister lid ˘
anti clockwise and remove from
the dust canister J.
K
3 Turn the central mesh filter ˜
clockwise to remove and clean
as required K.
4 Detach the pleated filter ˆ from
the dust canister lid ˘ by a firm
pull/twist action L.
5 Both the mesh and pleated
filters may be washed in warm
water (no detergent). Allow to air
dry. Ensure the filters are
thoroughly dry before refitting.
L
6 Re-locate the pleated filter back
into position on the dust
canister lid by aligning the tabs
on the dust canister lid L with
the cut away sections on the
pleated filter before pushing into
place.
Refit the mesh filter and turn
anti-clockwise to lock into
position on the dust canister lid.
M
Re-attach the dust canister lid
on to the dust canister by
aligning the arrows J. Then
rotate the lid clockwise to lock.
Motor protection
filter
The motor protection filter ¯ is
located underneath the dust
canister M.
N
1 Remove the dust canister.
2 Lift out the filter and shake over
a dustbin. The filter may also be
washed in warm water (no
detergents). Allow the filter to air
dry. Ensure the filter is
thoroughly dry before refitting.
3 Replace the filter.

Exhaust filter

The allergy exhaust filter should
be replaced every 6 months to
maintain the high performance
filtration. Call our helpline for
replacements.
The exhaust filter is located
below the dust canister
compartment.
1 Remove the exhaust filter grille
‚ N.
2 Remove the exhaust filter „ by
pulling forward at the top and
lifting away.
3 Fit the replacement filter.
4 Refit the grille.
5 Dispose of the used filter in the
dust bin.
HINTS AND TIPS

Safety cut-out

(Suction motor)
If the cleaner overheats a motor
protection thermostat will
automatically switch the motor
off. If this happens, switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least 60
minutes. Check the airways for
blockages, empty dust canister
and clean the filters before
restarting.
Safety cut out
(brush-bar motor)
If a large item or rug edge jams
the brush-bar a safety cut-out
will operate. If this happens
switch off and unplug before
cleaning the blockage. Wait 1
minute before switching back
on.
0 0 8 8 4 4 5 5 0 0 7 7 7 7 7 7 7 7 0 0 0 0 ( ( U U K K ) ) o o r r 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9 ( ( I I r r e e l l a a n n d d ) )
6