Changing And Cleaning The Exhaust Filter; Changing And Cleaning The Motor Protection Filter - Morphy Richards POD COMPACT BAGLESS VACUUM CLEANER - REV 2 Manual

New pod vc73121 rev 2
Reassemble
Replace the filter ensuring that the seal is
good.
Replace the pod onto the main body.
Changing and cleaning
the motor protection filter
This cleaner is fitted with a motor
protection filter.
NEVER USE THE VACUUM CLEANER
WITHOUT THIS IN PLACE.
20/3/03 10:09 PM
6
Page 7
To clean the motor protection filter
1 Remove the filter from the filter grille.
2 Rinse the filter in lukewarm water and dry
the filter completely.
3 Put the filter back into the filter grille and
reassemble.
Changing and cleaning
the exhaust filter
This filter should be replaced every 12
months or sooner if required.
Remove the exhaust filter grille by pulling
the locking tabs towards you. Remove the
used filter. Insert the clean micro exhaust
filter and replace the filter grille.
IMPORTANT
• All filters should be checked regularly for
signs of damage, preferably after each
cleaning task. The filters must be replaced
immediately if they become damaged.
• Always disconnect the cleaner from the
mains when checking filters.
• Always make sure all filters are fitted
before use. Failure to do so may result in
damage to your product.
• If the sound of the cleaner changes
slightly, clean the filters and check for
blockages.