Agp Cards; Removing An Agp Card - Dell Dimension T2310 Owner's Manual

NOTE:
You must install filler brackets over empty card-slot openings to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
Lower the retention arm and press it into place, securing the card(s) in the computer.
7
Close the computer cover (see page 102).
8
NOTICE:
the computer.
Connect your computer and devices to electrical outlets, and then turn them on.
9
Remove the card's driver from the operating system.
10

AGP Cards

CAUTION:
page 9.
Your Dell™ computer provides a connector for an AGP card.

Removing an AGP Card

Follow the instructions in "Before You Begin" on page 68.
1
Open the computer cover (see page 70).
2
Press the lever on the card retention arm and raise the retention arm.
3
Pull the card up and out of the card clip.
4
80
Removing and Installing Parts
To connect a network cable, first plug the cable into the network wall jack and then plug it into
Before you begin any of the procedures in this section, follow the safety instructions on
retention arm
AGP card
lever
edge connector
AGP connector
PCI connector