Checking/Changing Switch Settings - NEC VERSA LITEPAD TABLET PC Manual

Press
6.
update progress. Do not restart the system until the you are
instructed to restart.
update process can cause damage to the system.
Remove the diskette and press any key to continue. A CMOS
7.
Checksum message appears and prompts you to press
enter Setup.
Press
8.
settings.
Reconfigure Setup with the custom settings you documented for
9.
yourself before beginning this procedure.
Press
10.

Checking/Changing Switch Settings

The NEC Versa LitePad tablet PC has a four-position dip switch on the
bottom of the tablet PC. Switches are identified as follows:
Switch 1 — Password Override switch
The default setting is "OFF." If you forget the password you set in
the BIOS Setup utility and you cannot access BIOS Setup or
Windows, change the setting to "ON" and your current password is
erased.
Note
clear your Windows password.
Switch 2 — Logo Select switch
The default setting is "OFF" for the U.S. logo.
Switch 3 — Crisis Recovery Boot from Boot Block switch
The default setting is "OFF" for a Normal boot. The "ON" setting
is for a Boot block.
Switch 4 — Reserved for factory use. Default setting is "OFF."
3-16 Using the BIOS Setup Utility
and then press
Y
Interrupting the BIOS update during the
to enter Setup and restore the default parameter
DOWN
to save changes and exit Setup.
F10
Clearing the password set in the BIOS Setup utility does not
. A message informs you of the
Enter
to
DOWN