Removing A Cf Card; Monitor - NEC VERSA LITEPAD TABLET PC Manual

Removing a CF Card

To remove a CF Card, follow these steps.
Remove the CF Card from it slot by pressing the eject button next
1.
to the slot. Pull the card out. Store the CF Card in a static-free
container.
If you are not installing another CF Card, insert the previously
2.
removed slot cover into the slot to keep dust and dirt out.

Monitor

You can add a standard external monitor to your NEC Versa LitePad
tablet PC. You need a display signal cable (usually provided with the
monitor). One end of the cable must have a 15-pin connector for the
tablet PC.
Follow these steps to connect an external monitor to your tablet PC.
1. Check that the tablet PC is powered off and the monitor power
switch is turned off.
Note
suspended while the monitor is being connected.
Pull open the monitor port cover and attach the 15-pin cable
2.
connector to the VGA monitor port on the system (see "On the
Back of the Tablet PC" in Chapter 1 for the port location).
Secure the cable connection with the cable connector screws.
Connect the monitor power cable and plug it into a properly
3.
grounded wall outlet.
Follow any setup instructions in the monitor user's guide.
4.
Turn on power to the tablet PC and device.
5.
Note
LCD/CRT display. It does not support the display of the CRT only.
The NEC Versa LitePad tablet PC must be powered off or
The NEC Versa LitePad tablet PC supports simultaneous
Adding Expansion Devices 5-13