Table of Contents
Advertisement
A
D
LED I
IAGNOSING
NDICATORS
B
C
EFORE
ONTACTING
T
ROUBLESHOOTING
Table 4: LED Indicators
Symptom
Action
Power/LAN LEDs are off
◆
WLAN LED is off
◆
◆
LAN LEDs are off
(when port connected)
◆
◆
◆
T
S
ECHNICAL
UPPORT
Check the following items before you contact local Technical Support.
1.
If the Access Point/Repeater cannot be configured using a web
browser:
Be sure to have configured the Access Point/Repeater with a valid IP
■
address, subnet mask and default gateway.
Check that you have a valid network connection to the Access Point/
■
Repeater and that the Ethernet port or the wireless interface that
you are using has not been disabled.
If you are connecting to the Access Point/Repeater through the
■
wired Ethernet interface, check the network cabling between the
management station and the Access Point/Repeater. If you are
connecting to Access Point/Repeater from a wireless client, ensure
that you have a valid connection to the Access Point/Repeater.
If you forgot or lost the password:
2.
Set the Access Point/Repeater to its default configuration by
■
pressing the reset button on the back panel for 5 seconds or more.
– 85 –
The AC power adapter may be disconnected. Check
connections between the Access Point/Repeater, the power
adapter, and the wall outlet.
The access point radio has been disabled through it's web
management interface. Access the management interface
using a web browser to enable the radio.
Verify that the Access Point/Repeater is powered on.
Be sure cables are plugged into both the Access Point/
Repeater and corresponding PC.
Verify that the proper cable type is used and its length does
not exceed specified limits.
Check the cable connections for possible defects. Replace the
defective cable if necessary.
Advertisement
Table of Contents
