Table of Contents
Advertisement
Appendix B: Cables
Twisted-Pair Cable and Pin Assignments
For 10/100BASE-TX connections, a twisted-pair cable must have two pairs of wires.
For 1000BASE-T connections the twisted-pair cable must have four pairs of wires.
Each wire pair is identified by two different colors. For example, one wire might be
green and the other, green with white stripes. Also, an RJ-45 connector must be
attached to both ends of the cable.
Caution: Each wire pair must be attached to the RJ-45 connectors in a specific
orientation.
Caution: DO NOT plug a phone jack connector into any RJ-45 port. This will damage the
switch. Use only twisted-pair cables with RJ-45 connectors that conform with
FCC standards.
The figure below illustrates how the pins on the RJ-45 connector are numbered. Be
sure to hold the connectors in the same orientation when attaching the wires to the
pins.
10BASE-T/100BASE-TX Pin Assignments
Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45
connections: 100-ohm Category 3 or better cable for 10 Mbps connections, or
100-ohm Category 5 or better cable for 100 Mbps connections. Also be sure that the
length of any twisted-pair connection does not exceed 100 meters (328 feet).
Data and PoE power are delivered on the standard two wire pairs (pins 1, 2, 3, and
6). Since the RJ-45 ports on the switch support automatic MDI/MDI-X operation, you
can use straight-through cables for all network connections to PCs or servers, or to
other switches or hubs. In straight-through cable, pins 1, 2, 3, and 6, at one end of
the cable, are connected straight through to pins 1, 2, 3, and 6 at the other end of
the cable. When using any RJ-45 port on this switch, you can use either
straight-through or crossover cable.
Figure B-1 RJ-45 Connector Pin Numbers
8
8
1
1
B-1
Advertisement
Table of Contents
