Multi-Stitch Zig-Zag - Singer 6233 Manual

Position the hem under the presser
foot with the soft fold resting against
wall of the guide. Be sure the flange of
the guide is belween the soft fold and
the top of the hem, as shown.
. Lower the presser loot and begin
sewing making certain the straight
stitches fall on the edge of the hem
and the zig-zag stitches just pierce
the soft fold of the work. Adjust stitch
width il necessary. While stitching,
guide the hem edge in a straight line
and feed the soft fold evenly against
the wall of the guide.
. lf layers of fabric are pinned together,
remove pins as you cometo them. Do
not sew over pins.
Multi -Stitch Zig -Zag #8
Mending, overcasting,
joining or reinforcing can all be done using the Multi-Stitch Zig-Zag.
MendingaTear
r Trim ragged edges of tear.
o Cut a lining of fabric for reinforcement.
. Bring the edges otteartogether and baste
lining to wrong side of fabric.
RECOMMENOED
SETTINGS
Slltch Selectlon: Multi-Stitch
Stltch Wldth:
Stltch Lenglh:
Fool:
Needle Plate:
Zig-Zag@
itFElo
1 or l5li67
Special Purpose (J)
General Purpose
r Place tear, right side up, under presser
foot.
. Stitch over the line of the tear, shortening
stitch length at each end for reinforce-
ment.
o Trim thread ends close to fabric.
r lf needed, sew over tear again.
. Trim away lining close to stitching.
i:i
I
22