L M P Or T An Ts A F Eg Ua R Ds - Singer 6233 Manual

IMPORTANT SAFEG UARDS
1. Remove plug f rom the socket outlet when changing needles, feet, or needle
plates, or when leaving the machine unattended. This eliminates the
possibility of starting the machine by accidentally pressing the speed
controller.
2. Before removing the bobbin case, remove plug from the socket outlet.
3. Because of the up and down movement of the needle, you must work
carefully and watch the sewing area when operating the machine.
4. Do not pull the fabric while you are stitching as this may deflect the needle,
causing it to break.
5. Before cleaning your machine, remove plug from the socket outlet.
6. Do not attempt to adjust the motor belt. Contact your nearest Service
Center should any adjustment be required.
7. Before changing light bulb, make sure you have removed plug from socket
outlet. Be sure to replace the face plate which covers the light bulb before
operating the machine.
8 . T his m a c hi n e i s d es i g ne d to u s e a 1 S - wa t t ma xi mu m l i gh t b ul g .
9. This machine is double insulated. When servicing, use only identical
replacement parts.
This product ls suppressed tor radio and television interfercnce with the lnternational
Electrolechnical Commission requirements of the CISPR.
Machines for Great Britain and gome other countries having similar wiring standards
are shipped trom the tactory without a plug for connection to the mains. The wires
in this mains lead are coloured in accordance with the following code:
Blue: neutral (N)
Brown: live (L)
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked
with the letter N or coloured black. The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or coloured red. lf a 13 Amp. (BS
1363) plug is used, a 3 Amp. fuse must be fitted, or if any other type of plug is used,
a 5 Amp. tuse must be fitted either in the plug or adaptor or at the distribution board.
Neither core is to be connected to the earth terminal of a three-pin plug.