Clock And Timer; Setting The Clock; Setting The Sleep Timer - Aiwa XR- XR-M150 Operating Instructions Manual

CLOCK AND TIMER

SETTING THE CLOCK

VOL/
MULTI JOG
s
2
DEMO/ECO
2
1 Press DISPLAY on the remote control.
To set the clock during power off, press a
is displayed.
2 Within 4 seconds, press f or g to designate
the time, then press a.
Each time f or g is pressed, the time changes by 1
minute. To change the time by 30 minutes, press and hold
f or g.
• VOL/MULTI JOG is also available instead of f and g.
To display the current time
With power on, press DISPLAY once on the remote control. The
time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
When the power is off, press DEMO/ECO repeatedly until the
display changes to clock.
To switch to the 24-hour standard
With power on, press DISPLAY once on the remote control then
press s within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
09-14/XR-M150<U>/Eng
1
a a
a until the clock a
14

SETTING THE SLEEP TIMER

VOL/
MULTI JOG
2
1
The unit can be turned off automatically at a specified time.
1 Press SLEEP.
SLEEP
2 Within 3 seconds, press f or g to specify
the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
• VOL/MULTI JOG is also available instead of f and g.
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEPoFF" appears on the display.
10/4/2000, 5:09 PM
Specified time
14
ENGLISH
En