RECORDING
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
3
2
s
a
4
1
Preparation
• Use Type I (normal) tapes only.
• Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
2 Press TAPE/REV MODE to select the reverse
mode.
To record on one side only, select p.
To record on both sides, select [ or ].
When using the remote control, press MODE.
3 Press function (TUNER, AUX/VIDEO or CD) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press AUX/VIDEO and
play.
4 Press wREC/REC MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press s.
To pause recording, press a (applicable when the source is
TUNER or AUX/VIDEO). To resume recording, press it again.
11
ENGLISH
09-14/XR-M150<U>/Eng
MODE
11
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
INSERTING BLANK SPACE
Insertion of 4-second blank spaces may help you to locate the
beginning of the track on other equipments. This unit can add
blank spaces only when the source is TUNER or AUX/VIDEO.
1 Press wREC/REC MUTE during recording or while in
recording pause mode.
4 on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press a to resume recording.
To insert a blank space of less than 4 seconds, press
wREC/REC MUTE again while 4 is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters the recording pause mode, press wREC/REC MUTE
again.
Each time wREC/REC MUTE is pressed, a 4-second blank
space is added.
*This unit does not have the function to locate the beginning of track.
Recording cannot be done when TAPE function is selected.
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing TAPE/REV MODE.
4 Press AUX/VIDEO and turn the connected equipment off.
5 Press w REC/REC MUTE to start the erasure.
10/4/2000, 5:09 PM