Programmed Edit Recording - Aiwa XR- XR-M150 Operating Instructions Manual

PROGRAMMED EDIT RECORDING

s
8
1
In the programmed edit recording function, the track can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from step 2 to 7.
1 Insert the tape into deck.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press FUNCTION repeatedly until "CD" is
displayed and load the disc.
3 Press MODE repeatedly until "PRGM EDIT"
appears on the display.
"EDIT" lights up and "PRGM" flashes on the display.
PRGM EDIT
4 Press numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and 0.
• The f and g are also available to designate the tape
length.
Tape length
13
ENGLISH
09-14/XR-M150<U>/Eng
4, 5
3, 7
2
f, g
Maximum recording
time for side A
Tape side A
(front side)
13
5 Press the numbered buttons 0-9 and +10 to
program a track.
Example : To select the 10th track, press +10 and 0.
Selected Program
track number
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press MODE to select side B and program the
tracks for side B.
After confirming "B" on the display, repeat step 5.
Tape side B (reverse side)
8 Press w w w w w REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press s. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press MODE on the remote control to select
side A or B, and press f or g repeatedly.
Program
Track number number
Tape side
To change the program of each side
Press MODE on the remote control to select side A or B, and
press s to clear the program on the selected side. Then program
tracks again.
To clear the edit program
Press s twice so that "EDIT" disappears on the display.
• Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
10/4/2000, 5:09 PM
Remaining Programmed
time of side A track
Programmed
track numbers