Page 1
For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. Model No. Serial No. (Lot No.)
WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage”...
Outdoor Antenna Power lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
PREPARATIONS Connection Plug in the AC power cord to the AC outlet after all other connections are made. 1 Connect the speaker cords to the speakers. Connect the copper cords to the + terminals and the silver cords to the – terminals. 2 Connect the speakers to the main unit.
PARTS AND CONTROLS Main unit 1 POWER 6STANDBY/ON Switches the unit on and off (standby). 2 TUNER/BAND Selects Radio function and the radio band. Selects the function of external equipment connected to VIDEO/AUX IN jacks. Starts and pauses play. 3 ECO/DIMMER Selects ECO mode and dimmer mode.
Page 6
Remote control Buttons with the same or similar names on the main unit basically have the same function. 1 POWER 2 0–10, +10 CD: selects a track of the specified number. Radio: tunes in the station with the specified preset number.
ADJUSTMENTS BEFORE OPERATION ECO/DIMMER POWER 6STANDBY/ON TUNER/BAND, AUX, CD Power Turning the unit on Press POWER 6 STANDBY/ON (POWER on the remote control). Alternatively, press TUNER/BAND, AUX or CD. Playback will start automatically if a disc is loaded. Turning the unit off Press POWER 6STANDBY/ON again.
CD OPERATIONS DISPLAY zOPEN/CLOSE This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing a CD 1 Press z OPEN/CLOSE to open the disc compartment. Place a disc with the label side up. Then close the disc compartment by pressing z OPEN/CLOSE.
Random/Repeat play In random play mode the unit plays all the tracks in random order. In repeat play mode it plays repeatedly all the tracks or the track being played. You can select random and repeat all play at the same time. 1 Press RANDOM/REPEAT repeatedly on the remote control.
RADIO OPERATIONS TUNER/BAND POWER PRESET Manual tuning 1 Press TUNER/BAND repeatedly to select a band. The unit switches to the radio from any other function and alternates between FM and AM. 2 Press f or g repeatedly to tune in a station. "TUNE"...
Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that "MONO" is displayed. To cancel, repeat the above so that "STEREO" is displayed. Tip: When FM stereo reception is poor, switching to monaural reduces noise.
TIMER OPERATIONS TUNER/BAND, AUX, ECD POWER VOLUME 6STANDBY/ON Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press SET. 2 Within 6 seconds, press f or g to set the time.
Timer playback Turns on the unit at a specified time for the specified duration. Make sure the clock is set correctly. 1 Hold down SHIFT and press TIMER on the remote control. "5" lights up and " PLAY" is displayed. 2 Within 12 seconds, press SET.
REFERENCE Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. To clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution.
Specifications MAIN UNIT CX-LX77 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminal 75 ohms (unbalanced) AM tuning range 530 kHz to 1710 kHz (10 kHz step) 531 kHz to 1602 kHz (9 kHz step) AM usable sensitivity 350 µV/m AM antenna...
Page 16
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.