Advertisement
1
2
use and maintenance Scarabeo 50
20
1a
- Scarabeo 100 4T
CONTROLS ON THE RIGHT SIDE OF THE
HANDLEBAR
NOTE
The electrical parts work only when the ignition switch is in
position "
".
NOTE
The lighting system works only when the engine is run-
ning.
•
1) LIGHT SWITCH (
-
)
NOTE
Before operating the light switch, make sure that the
dimmer switch (
-
) is in position "
When the light switch is in position "
position "
", the parking lights, the dashboard light and the low
or high beam are on.
The low or high beam can be operated by means of the dimmer
switch (
-
).
1a) DIMMER SWITCH (
-
When the dimmer switch is in position "
parking and the dashboard lights are on; when it is in position
"
", the high beam, the parking and the dashboard lights are on.
NOTE
The lights can be switched off only by stopping the en-
gine.
2) START PUSH BUTTON (
When the start push button is pressed and one of the brake
levers (front or rear) is activated at the same time, the starter
makes the engine run.
For the starting, see page 38 (STARTING).
".
•
", the lights are off; in
)
", the low beam, the
)
Advertisement
