APRILIA RSV MILLE R TUONO - 2002 Manual page 43

MULTIFUNCTION (RIGHT DISPLAY)
The right display (multifunction) includes
the coolant temperature in °C (°F) (8) and
the digital clock (7) as standard settings.
NOTE
When the engine is cold, the
writing "" blinks.
By pressing the push button , the
following functions can be obtained in
sequence:
Standard setting: Temperature in °C
and digital clock

Battery voltage (V BATT)

Setting the hour

Setting the minutes

Setting °C or °F
S T A N D A R D S E T T I N G : C O O L A N T
TEMPERATURE AND DIGITAL CLOCK
The coolant temperature value (8) is
shown in the upper part of the right display.
It is possible to switch from °C to °F and
viceversa, see p. 44 (SETTING °C OR °F).
– When the temperature is below 35°C

(95°F), the writing "
the right display.
– When the temperature is over 115°C
(239°F), the value (8) blinks on the right
display, even if a function different from the
standard setting has been set.
– When the temperature is over 130°C
LLL
(266°F), the writing " " (8) appears on
the right display.
LLL
If the writing " " is displayed with a
temperature below 130°C (266°F), there
may be a failure of the electric circuit. In
this case, contact an aprilia Official
Dealer.
Thermometer range on the display: 35–
130°C (95–266 °F).
The digital clock (7) appears in the lower
part of the right display. To set or modify
hour and minutes, see p. 44 (SETTING
T H E H O U R ) a n d ( S E T T I N G T H E
" (8) blinks on
MINUTES).
BATTERY VOLTAGE - VBATT
If the push button  is pressed once, the
◆
battery voltage expressed in volt (19)
appears in the lower part of the right
display, while the coolant temperature
(8) is displayed in the upper part. The
writing "V BATT" (20) is displayed. The
recharge circuit functions correctly if at
4000 rpm the battery voltage with low
beam on is included between 13 and 15
V.
use and maintenance RSV mille TUONO
 
43
- RSV mille R TUONO