Table of Contents
Advertisement
NOTE
To check the direction of the
headlight beam, specific procedures must
be adopted, in accordance with the regula-
tions in force in the country where the vehi-
cle is used.
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
92
use and maintenance RSV mille - RSV mille R
To adjust the headlight beam:
N
Position the vehicle on the side stand on
firm and level ground.
N
Working on the rear left side of the front
part of the fairing, adjust the apposite
screw (1) by means of a short cross-tip
screwdriver.
By SCREWING IT (clockwise), you set
the beam upwards.
By UNSCREWING IT (anticlockwise),
you set the beam downwards.
Carefully read p. 55 (MAINTENANCE).
WARNING
Risk of fire.
Keep fuel and other flammable sub-
stances away from the electrical com-
ponents.
CAUTION
Before changing a bulb, move the igni-
tion switch to position " " and wait a
few minutes, so that the bulb cools
down.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC
CABLES.
NOTE
Before changing a bulb, check the
fuses, see p. 90 (CHANGING THE FUS-
ES).
Hide quick links:
Advertisement
Table of Contents
