APRILIA RSV MILLE - REGULAR SERVICE Manual page 12

REASSEMBLY
CAUTION
Before proceeding with the reassembly,
make sure that support plate (8) of the
brake caliper (9) is positioned correctly;
the plate slot must be inserted in the ap-
propriate stop pin (10) in the inner part
of the rear fork right rod.
Insert the disc in the brake caliper care-
fully.
N
Spread a film of lubricating grease on the
whole length of the wheel pin (3), see
p. 103 (LUBRICANT CHART).
N
Position the right (6) and left (7) chain
tighteners in their seats on the rear fork
arms.
N
Position the wheel between the rear fork
rods on the support (2).
N
Make the wheel advance and position
the drive chain (4) on the crown gear (5).
WARNING
Danger of injury.
Do not introduce your fingers to align
the holes.
N
Move the wheel backwards, until its cen-
tral hole and the holes on the rear fork
are aligned.
N
Rotate the support plate (8), complete
with brake caliper (9) and with fulcrum on
the stop pin (10), until it is aligned with
the holes.
N
Introduce the wheel pin (3) completely
from the left side.
CAUTION
Make sure that the wheel pin (3) is in-
serted completely, with the head in the
appropriate seat on the left chain tight-
ener (7).
N
Position the washer and tighten the nut
(1) manually.
N
Check the chain tension, see p. 68
(DRIVE CHAIN).
N
Tighten the nut (1).
Wheel nut (1) driving torque:
120 Nm (12 kgm).
N
Make sure that the following components
are not dirty:
– tyre;
– wheel;
– brake discs.
CAUTION
Check the wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
use and maintenance RSV mille - RSV mille R
67